1、排煙口類型應與設計一致。除擔負一個防煙分區的排煙系統，可以用普通常開風口外，排煙口均應采用常閉且具備遠程+就地控制的遠控金屬風口。

　　1. The type of smoke exhaust should be in accordance with the design. In addition to assume a smoke exhaust system can be partitioned, with ordinary open air outlets, the exhaust port shall be normally closed and have remote control on the remote control + metal tuyere.

　　2、手動開啟裝置應安裝在明顯位置且有消防標志。

　　2, manual opening device should be installed in an obvious position, and there are fire signs.

　　3、排煙口執行機構安裝到位且排煙口的有效進風面積滿足設計要求。

　　3. The smoke exhaust port actuator is installed in place and the effective air intake area of the smoke exhaust port meets the design requirements.

　　4、排煙口安裝位置建議在高處安裝，至少距地面不應低于1.8米。

　　4, smoke exhaust port installation position must be installed at high altitude, at least away from the ground should not be less than 1.8 meters.

　　5、檢查防煙分區的設置、圍合是否滿足要求，排煙口是否安裝在相應的防煙分區內且與設計位置一致(位置變動有可能保護距離大于30米)。

　　5, check whether the setting of the smoke prevention zone, whether the enclosure meets the requirements, whether the smoke discharge port is installed in the corresponding smoke prevention area, and consistent with the design position (location change, it is possible to protect the distance is greater than 30 meters).

　　1、風口類型應與設計一致。前室送風除擔負2層以內的正壓送風系統可以用普通常開風口外，其余均應采用常閉且具備遠程+就地控制的遠控金屬風口。樓梯間送風一般采用自垂風口等常開風口。

　　1, tuyere type should be consistent with the design. Room air in addition to assume 2 layers within the positive pressure air supply system can be used in ordinary open wind estuary, the rest are normally closed and should be used with the remote control on the remote control + metal tuyere. The air supply in the stairwell usually adopts the self opening air inlet and so on.

　　2、檢查風口的開啟狀態與設計一致(遠控風口平時均應處于關閉狀態)。

　　The open state is consistent with the design of 2, check the air (usually air remote control are to be in closed state).

　　3、執行機構安裝到位且不影響風口的有效通風面積。

　　3 、 the installation of the actuator is in place and does not affect the effective ventilation area of the air outlet.

　　4、檢查手動開啟裝置手否在明顯位置且方便開啟。

　　4, check manual open device, hand no obvious position, and easy to open.

　　您的需求就是我們努力的方向，您的追求就是我們的追求，歡迎您的到，我們一起進步，一起創新!

　　Your demand is the direction of our efforts, your pursuit is our pursuit, welcome you, and we progress together, together with innovation!

上一篇：關于通風管道節能原理的相關介紹
下一篇：油煙的主要來源和解決方案